OmniSistem PR XS 250 - Manual (Page 11)

11/22
ERROR MESSAGES
In the course of launch, XS 250 examines automatically whether there are errors and if there are, it will display
information as follows:
Display Message
SE 1 Zoom (1# motor) error
SE 6 Rotating Gobo wheel (6# motor) error
SE7 Gobo rotation 1 (7# motor 1) error
SE 9 Fixed Gobo wheel (9# motor) error
SE10 Colour wheel (10# motor) error
REPLACING GOBOS
Disconnect the fixture from power. Lock Tilt. Carefully lift off the cover by undoing the 6 screws.
For gobos replacement on the fixed gobo: Remove the gobo and insert the new one into the position by hands.
For gobos replacement on the rotating gobo wheel: Remove the gobo holder with gobo from gobo wheel by
hands.
Pull out the spring and drop the old gobo out of the holder.
Insert the new gobo into the holder, and then insert the spring with the narrow end against the gobo.
Push the end of the spring in under lip of the holder.
Pick the spring clip up and put the gobo holder back into the position, if necessary, a small screwdriver will be
helped.
Note: If the gobo is a glass one, it should be touched with glabrous, clean and soft tissue or cloth matted between hand
and glass instead of with bare hand.
Close the rear cover and fasten 6 screws.