Cisco IP Phone 7961G-GE - Manual (Page 25)

4-25
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE Administration Guide for Cisco Unified CallManager
OL-11528-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Enable this option if an application that requires monitoring of the phone’s traffic
is being run on the access port. These applications include monitoring and
recording applications (common in call center environments) and network packet
capture tools that are used for diagnostic purposes.
Use Cisco Unified CallManager Administration > Device > Phone >
Phone Configuration.
Security Configuration Menu
The Security Configuration menu that you display from the Device Configuration
menu displays settings that relate to security for the phone.
Note The phone also has a Security Configuration menu that you access directly from
the Settings menu. For information about the security options on that menu, see
the
“Security Configuration Menu” section on page 4-29 .
Table 4-7 describes the options on the Security Configuration menu.
Table 4-7 Security Configuration Menu Options
Option Description To Change
PC Port Disabled Indicates whether the access port on the
phone is enabled (Yes) or disabled
(No).
Must be set to enabled for video
support on the phone
Use Cisco Unified CallManager
Administration > Device > Phone >
Phone Configuration.
GARP Enabled Indicates whether the phone learns
MAC addresses from Gratuitous
Address Resolution Protocol (ARP)
responses. Disabling the phone’s
ability to accept Gratuitous ARP will
prevent applications that use this
mechanism to monitor and record voice
streams from working. If voice
monitoring is not desired, set this
option to No (disabled). Use Cisco Unified CallManager
Administration > Device > Phone >
Phone Configuration.