Compact Power Boxer 427W - Manual (Page 28)

6-7-06 - Fifth Proof
3-2
Pre-Start Inspection and Operation
Do the following pre-start service checks:
1. Check condition of all warning and instructional decals. Replace any damaged decals with
genuine CPI replacement decals.
2. Check engine oil -
• Make sure that the engine is OFF.
• Pull out the dipstick and look for both the full and add oil lines (Item 1, Figure 3–1)
indicated by the letters “F” and “A”. The correct oil level is between those two lines.
Figure 3–1 Engine Oil Level Check
• If the engine oil level is below the add line, indicated by the letter “A” on the dipstick,
carefully add the proper amount of oil through the engine oil filler tube (Item 1, Figure 3–1).
It is important to add the correct type of engine oil as stated in the engine manual.
NOTE: Extremely dusty or dirty working conditions may require more frequent checking,
filling and/or changing of engine oil.
• After filling the oil, wait a few minutes and check the oil level again.
Make sure to securely reinstall the dipstick into the dipstick tube before starting the
engine.Check engine fuel and fill as needed - be sure engine is OFF
3. The Brute has two saddle gas tanks (Item 1, Figure 3–2). Each of the tanks has a gas gauge
located in the filler cap (Item 2, Figure 3–2). Remove cap and visually inspect fuel level to
make sure that the indicator is showing the proper fuel level. Make sure that each tank has
been filled on a daily basis.
1
OK
x
x
x
x
x
F
A
2130
IMPORTANT