Cub Cadet SERIES 3000 TRACTOR GT 3200 - Manual (Page 26)

26
Headlight Bulb Replacement
Replace headlight bulbs as follows:
(See Figure 17)
1. After noting which wire connects
to each terminal, unplug the wire
harness leads from the headlight
socket terminals.
2. Rotate the socket assembly as
follows to remove from the
reflector housing:
Figure 17
• Left headlight — approximately 1/
4 turn counterclockwise.
• Right headlight — approximately
1/4 turn clockwise.
3. Push the bulb inward and turn
counterclockwise to remove from
the socket.
4. Align the post of the bulb base
with the notch in the socket, then
push the bulb inward and turn
clockwise to lock
5. With the terminals pointing
upward, align the tab of the
socket with the notch of the
reflector. Push the socket inward
and turn as follows to lock:
• Left headlight-1/4 turn clockwise.
• Right headlight-1/4 turn counter-
clockwise.
6. Connect the wire harness leads to
the appropriate socket terminals.
Adding Transmission Oil
WARNING: The fluid for your
transmission has been spe-
cially formulated to ensure
the safe and proper opera-
tion of your tractor. Add Cub
Cadet Drive System Fluid
Plus ONLY. Do not use any
other fluid.
WARNING: Never overfill the
transmission case. Damage
may result if the oil level in the
transmission case is below
the “ADD” mark or over the
“FULL” mark of the dipstick.
For best results, fill to the “FULL” mark
on the dipstick as opposed to adding a
given quantity of oil. Always check the
level on the dipstick before adding
more oil. Refer to Figure 15.
Refer to the Lubrication Illustration for
information regarding the proper type
of oil to add to the transmission case.
See the Specifications Chart for the
quantity required.
• Place the tractor on a level surface
and engage the parking brake. Stop
the engine and remove the ignition
key.
• Clean the area around the
Transmission Oil Fill /Dipstick to
prevent debris from entering the
transmission case.
• Remove the dipstick from the oil fill
tube and SLOWLY pour oil into the
oil fill tube. Fill the transmission
case until the oil level reaches the
“FULL” mark on the dipstick.
• Reinstall the dipstick securely into
the oil fill tube.
WARNING: The oil fill plug/
dipstick must be installed
securely into the fill tube at
all times when the engine is
operating.
Terminals
Socket
Reflector Housing
Reflector Notch
Socket Tab