Cub Cadet SERIES 3000 TRACTOR GT 3200 - Manual (Page 29)

29
From just above the right axle carrier,
inside the right frame rail, slowly turn
the hex nylon lock nut at the end of
the brake rod as follows to adjust the
brake (Refer to Figure 23):
• Turn the nylon lock nut clockwise to
increase the braking force.
• Turn the nylon lock nut counter-
clockwise to decrease the braking
force.
Figure 23
Recheck the brake adjustment to
ensure proper operation, and readjust
as necessary. If brake adjustment
does not correct the problem, see your
authorized Cub Cadet dealer.
While guiding the transmission release
rod through keyhole and the oil fill
tube/dipstick into the transmission,
reinstall the rear drawbar on the
frame. Secure with the four hex tapp
screws.
Changing the Engine Oil and Filter
Warning! If the engine has
been recently run, the en-
gine, muffler and surround-
ing metal surfaces will be
hot and can cause burns to
the skin. Exercise caution
to avoid burns.
The oil filter should be changed at
every oil change interval. The filters
can be obtained through your Cub
Cadet dealer. Refer the engine opera-
tor’s manual, or the condensed engine
information in the next section of this
manual, for information regarding the
frequency of required oil changes and
the quantity of oil needed. To drain the
engine oil, proceed as follows:
• Run the engine for a short time to
warm the engine oil. The oil will flow
more freely and carry away more
impurities Use care to avoid burns
from hot oil.
• Locate the oil drain port and filter on
the left side of the engine.
• Pop open the protective cap on the
end of the oil drain valve to expose
the drain port. See Figure 24.
Remove the dipstick from its tube.
Figure 24
• Push the oil drain hose (packed with
this manual) onto the oil drain port.
Route the opposite end of the hose
into an appropriate oil collection
container with at least a 2.5 quart
capacity, to collect the used oil.
VIEWED FROM ABOVE - FENDER
AND RUNNING BOARD REMOVED
Brake Link
Brake Rod Brake Shaft
Hex Shaped
Flange
Assembly
Brake Assembly
(On Transmission)
Hex Nylon
Lock Nut
Oil Filter
Oil Drain
Valve