Crimestopper Security Products CS-2205 - Manual (Page 30)

30
3. To exit programming mode, take no action for five seconds. The remote control will generate two long beeps to indicate
programming mode has been exited.
System’s Status Check: When you want to check the system’s present status through the 2-Way remote control
transceiver, Press the button first, within 3 seconds press and button at same time, with one melody sound and all
the system’s present status will immediately displayed on the LED.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSCEIVER
Armed
LED turns on for 3 seconds
Disarmed LED turns on for 3 seconds
Valet mode Z LED turns on for 3 seconds
Hood/Trunk Ajar LED pause flash for 10 seconds
Door Open LED pause flash for 10 seconds
LAST TRIGGER MEMORY RETRIEVAL: If you want to retrieval last trigger’s memory. Press button first, within 3 seconds
press (M) button, with one melody sound and the last trigger’s memory storage in the transmitter will immediately display
on the LED.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSCEIVER
Hood / Trunk Trigger
LED and all of the back-light buttons pause flash for 10
seconds
Door Trigger
LED and all of the back-light buttons pause flash for 10
seconds
Shock Sensor
Trigger
LED and all of the back-light buttons pause flash for 10
seconds
Ignition Trigger
LED and all of the back-light buttons pause flash for 10
seconds
Driver Paging / Lose & Found: It is useful the event that someone wants to page the driver of the parked vehicle or
someone cannot find his LCD motorcycle remote transceiver.
Indoor Driving Paging: Under the ignition switch “off” condition, press and hold the valet switch for 2 seconds to page the
driver, one chirp sound shall be emitted from the vehicle and the paging melody sound continues sounding from your 2-way
remote control transceiver.