Compaq HB1004 User Manual
Page 23
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-5
Compaq HB1004 10Base-T Hub User Guide
Writer: Weldon W. Rowan Project: Setup and Configuration Comments:
File Name:SAB_3.DOC Last Saved On:7/2/98 4:53 PM
NOTE: The Compaq HB1004 System Configuration Program allows selection of
COM Ports 1, 2, 3 or 4 and assumes the normal default IRQ for the appropriate
port (i.e. COM1 is IRQ4, COM2 is IRQ3, COM3 is IRQ4 and COM4 is IRQ3). If
your communication port is configured differently, it is necessary to specify the
correct IRQ for that port. If this is the case, type:
A:\HB1004CP /i[irq#]
or
B:\HB1004CP /i[irq#]
in the Open box.
Figure 3-3 Communication Port Dialog Box
2.
Using arrow keys, select the workstation’s communication port
connected to the hub and press <Enter>. The DCE/DTE dialog box
appears as shown in Figure 3-4.