Compaq HB1004 - Manual (Page 39)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B-4 Troubleshooting
Writer: Weldon W. Rowan Project: Troubleshooting Comments:
File Name:SAB_B.DOC Last Saved On:7/2/98 2:37 PM
Using Diagnostic Mode
When you power up the HB1004 hub, the unit executes a self-test. If the
management agent fails the self-test the unit will not become active and the
diagnostic LED will remain lit. Run the Compaq HB1004 System
Configuration Program to open the Diagnostic Mode Main Menu. The
Diagnostic Mode provides a limited set of tools to assist you in resolving the
problem and getting the unit operational. Figure B-2 shows the Diagnostic
Mode Main Menu screen.
Figure B-2. Diagnostic Mode Main Menu
Configuration
Select Configuration to view and modify the hub configuration parameters. See
Chapter 3 “Changing System Configuration” for an explanation of the entries in
this screen shown in Figure B-3.
Figure B-3. Diagnostic Mode Configuration Screen