Casablanca Fan Company Modena II C10GXXM - Manual (Page 5)

5
M
odena
®
II
Prepare for fan installation as follows:
Step 4. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Step 5. Using the provided allen wrench, loosen the set
screw several turns to allow installation of the downrod.
Thread the downrod into the motor coupling until it stops
turning, this will take at least four and a half full turns.
Step 6. Securely tighten the set screw with the provided
allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod before
securely tightening the allen set screw may cause
the fan to separate from the downrod during normal
operation!
WARNING! DO NOT REMOVE THIS LABEL AND TAMPER
WITH ANTI-ROTATION BOTTOM SET SCREW! Unscrew-
ing the bottom set screw may cause fan to separate
from the motor shaft during normal fan operation
and may cause injuries!
Tip: The downrod has a tapered
thread that is designed to lock com-
pletely when correctly installed.
FAN PREPARATION
mOTOR
COUpLINg
TApERED
THREAD
gROUND
WIRE
ALLEN
SET SCREW
DOWNROD
& bALL
ASSEmbLy
mOTOR WIRES
BLADE INSTALLATION
bLADES
(Set of 5)
SCREW (3 pER bLADE)
Step 7. Take one blade and align it onto the blade iron of
the fan. There is only one way it will fit. Align the blade
medallion on to the blade and install the 3 screws per
blade. Secure by hand only, do not use a power tool.
bLADE mEDALLION
(5)