Sony CDX-M700R - Manual (Page 35)

35
Changing the sound and
display settings
The following items can be set:
Set (setting)
• Clock (page 9)
• CT (Clock Time) (page 23)
• Beep — to turn the beeps on or off.
• RM (Rotary Commander) — to change the
operative direction of the controls of the
rotary commander.
— Select “norm” to use the rotary
commamder as the factory-set position.
— Select “rev” when you mount the rotary
commander on the right side of the
steering column.
• English/Spanish/Portuguese/Swedish — to
change the display language to English,
Spanish, Portuguese or Swedish.
Dis (Display)
• Dimmer — to change the brightness of the
display.
— Select “Auto” to dim the display only
when you turn the lights on.
— Select “on” to dim the display.
— Select “off” to deactivate Dimmer.
• Contrast — to adjust the contrast if the
indications in the display are not
recognisable because of the unit’s installed
position.
• D.Info (Dual Information) — to display the
clock and the play mode at the same time (on)
or to display the information alternately (off).
• M.Dspl (Motion Display) — to turn the
motion display on or off.
• A.Scrl (Auto Scroll)* 1 (page 11)
Snd (Sound)
• EQ Tune* 2 (Equalizer tuning) — to adjust the
frquency and volume level of equalizer
curve.
• Front HPF* 2 (High pass filter for the front
pre-output) — to select the cut-off frequency
of the front pre-output.
• Rear HPF* 2 (High pass filter for the rear pre-
output) — to select the cut-off frequency of
the rear pre-output.
• SUB LPF (Low pass filter for the subwoofer
output)* 2 — to select the roll off frequency of
the subwoofer output.
1
Press (MENU).
2
Press M or m repeatedly until the desired
item appears.
Each time you press
m, the item changes as
follows:
Example
Clock t CT t Beep t RM t English/
Spanish/Portuguese/Swedish t D.Info t SA
t Dimmer t Contrast t M.Dspl t A.Scrl* 1
t EQ tune* 2 t Front HPF* 2 t Rear HPF* 2 t
SUB LPF* 2
* 1 When no CD or MD is playing, this item will
not appear.
* 2 CDX-M700R only
Note
The displayed item will differ depending on
the source.
Tip
You can easily switch among categories (“Set,“
“Snd,“ “P/M“ (Play Mode) and “Dis“) by
pressing M or m for two seconds.
3
Press , to select the desired setting
(Example: on or off) or press < or ,
repeatedly to select the frequency
(Example: off, 78 Hz or 125 Hz).
For the “Contrast” setting, pressing
,
makes the contrast higher, and pressing <
makes the contrast lower.
4
Press (ENTER).
After the mode setting is completed, the
display returns to normal play mode.