CatEye EC-37OO - Manual (Page 10)

12
R EC-3700
Handling the pulse(earlobe) sensor
cable hook
sensor clip
cable holder
sensor clip
pulse (earlobe) sensor
cable clip
This model detects and
displays your pulse rate
during exercise by the
pulse sensor from your
earlobe. Being a sensitive
electronic part, the pulse
sensor must be handled
with sufficient care.
pulse sensor
jack
pulse sensor plug
1
Installing the pulse
sensor
• Insert the pulse sensor plug into
the pulse sensor jack on the back
of the control unit, and hang the
sensor cable on the cable hook.
• Attach the cable holder at the bot-
tom of the seat pipe.
• Insert the sensor cable through
the 3 cable hooks and cable
holder. Hold the cable in position
by attaching the sensor clip at the
bend of the handlebar.
• Allow enough slack in cable under
the seat pipe for seat adjustment.
2
Use of sensor clip
• Always clip the pulse sensor to the
sensor clip when it is not being
used. This sensor clip can also be
used to adjust the slack of the
cable.
13
pulse (earlobe) sensor
3
Using pulse sensor
during exercise
• Clip the pulse sensor at the center
of your either ear lobe.
• Ear rings or other ornaments must
be removed before attaching the
sensor and during exercise.
• When it is cold, massage your ear-
lobe before use to improve blood
circulation.
• Try not to change the position of
the pulse sensor during the exer-
cise.
• If the E symbol frequently lights
up during use, remove once and
re-attach the pulse sensor.
• Attach the cable clip to your
clothes to prevent excessive swing-
ing of the sensor cable.
• Always keep the pulse sensor at-
tached on the sensor clip when it is
not in use. This sensor clip can also
be used to adjust the slack of the
cable.
• When removing the pulse sensor
after exercise, be sure to remove
also the cable holder.
Caution: Treat the pulse sen-
sor with care. The cable can be
damaged if pulled strongly.
4
Checking the Pulse
Sensor
• You can check the function of the
pulse sensor on the LCD screen
during the exercise.
• Remove the pulse sensor from
your earlobe during exercise, then
close it.
• The pulse sensor is normal if the
pulse rate drops to zero and the
symbol goes out.
• If the pulse rate does not drop to
zero or if the symbol remains,
the cable may be disconnected. If
the cable proves to be discon-
nected, replace the pulse sensor
with a new one (sold separately).
cable clip
pulse (earlobe) sensor