Philips MC5037 - Manual (Page 19)

Radío Reception
Storing Preset Radio Stations
You can store up to 40 preset radio stations in
the memory
Automatic Preset Programming
Plug and Play setting (refer to “Basic Functions -
Plug and Play").
OR
Press TUNER to select TUNER mode,
-♦ "TUNER" will be displayed. A few seconds
later the current radio frequency will appear on
the display.
^ If an FM station is received in stereo, co will
appear on the display.
To begin automatic preset from a desired
preset number
Press I'd or ►! to select the desired preset
number
-» If a radio station has been stored in one of
the presets, it will not be stored again under
another preset number.
Press and hold PROG until "fHJTO" appears on
the display.
PROGRAM will start flashing.
-> The system will start searching for all radio
stations on the FM band and then the AM band.
-» All available radio stations with sufficient signal
strength will be stored automatically.
•d The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
•d The last preset radio station will then be
played when completed.
To stop storing the automatic preset
• Press PROG or ■ on the system.
Note:
- If no preset number is selected, automatic preset
will begin from preset (1j and all your former
presets will be overridden.
Manual Preset Programming
Press TUNER repeatedly to select the desired
waveband : FM or AM.
Press PROG,
PROGRAM will start flashing.
The next available preset number will be
displayed for selection.
Press and hold or ►► until the frequency
indication starts to change, then release.
-> The display will show "5ERRCH" until a
radio station with sufficient signal strength is
found.
To store the radio station to another
preset number
Press M or ►! to select the desired preset
number
Press PROG again to store the radio station.
PROGRAM will disappear from the display
Repeat steps 2-4 to store other preset radio
stations.
19