Chicago Electric POWER TOOL 94362 User Manual
Page 14
Page 14
SKU 94362
For technical questions, please call 1-800-444-3353.
To Adjust The Depth Of Cut:
1.
WARNING! Prior to performing this procedure, make sure the Trigger Switch
(66) of the Saw is in its “OFF” position and the Power Cord (71) is unplugged
from its electrical outlet.
2.
The Saw may be adjusted to cut to a
maximum
depth of 2-1/4”.
3.
When adjusting the depth of cut, always make sure the
teeth
of the Saw Blade
(10) cut (or protrude) about 1/4” through the bottom surface of the workpiece.
4.
To adjust the depth of cut, pull up on the Lock Lever (50) located at the rear of the
Saw. (See Figure E.)
5.
Raise or lower the Base (24) until the desired cutting depth is acquired. Then,
push down on the Depth Control Lever (52) to lock the Base in place.
(See Figure E.)
FIGURE E
Depth Control Lever (52)
To Install A Saw Blade:
1.
WARNING! Prior to performing this procedure, make sure the Trigger Switch
(66) of the Saw is in its “OFF” position and the Power Cord (71) is unplugged from
its electrical outlet.
2.
CAUTION! Always make sure the Saw Blade (10) installed is a 7-1/4”
diameter, metal cutting saw blade, with an RPM rating of 5,800 or greater.
BASE (24)