Compex Systems WPE53G - Manual (Page 173)

Page 167
Appendix: Use the Command Line
Interface
Get Operation List
SYNTAX DESCRIPTION
Get tasks Display all active process/tasks.
Get sysinfo Display system information.
Get aplist Display list of access points discovered.
Get athstats Display wireless driver information.
Get brinfo Display bridge and interfaces information.
Get brmacshow Display bridge learned MAC address list.
Get bssinfo. Display current radio information.
Get channel Display current wireless channel number.
Get chanlist Display current domain wireless channels.
Get ieee80211stats Display ieee80211 protocol statistics.
Get routeshow Display the routing table information.
Get stalist Display a list of currently associated stations.
Get linkinfo Display client link information (Client mode only)
Get macstats Display a list of currently learnt wireless device MAC addresses.
Get opmode Display current wireless operation mode.
Get wmode Display wireless mode
Set Operation List
SYNTAX DESCRIPTION
Set factorydefault Set factorydefault – restore configuration to factory default.
Restart Do a warm reboot.
Save Configuration
SYNTAX DESCRIPTION
Commit Save current configuration to flash.
Most commands require rebooting to take effect after saving.
Long Range
Check for recommended values from long distance option setup page.
SYNTAX DESCRIPTION
Set outdoor <enable/disable> Enable outdoor for long-range connection.
Set distance <value> Set the connection distant (value in decimal)
Set acktimeout <value> Set the ACK timeout (value in decimal)
Set ctstimeout <value> Set the CTS timeout (value in decimal)
Set slottimeout <value> Set the Slot timeout (value in decimal)
TX Power
SYNTAX DESCRIPTION
Set txpower <string> (Default full) auto, 1, 2, 3, 4, ..., 17, full, min
TX Rate
SYNTAX DESCRIPTION
Set txrate <string> Values are: (default auto)
(802.11a)-- 6, 9, 12, 18, 24, 36, 48, 54, auto (Version AG)
(802.11b/g mixed)-- 1, 2, 5,5, 11, 6, 9, 12, 18, 24, 36, 48, 54, auto
(802.11b-only)-- 1, 2, 5.5, 11, auto