Speaker distance thx audio setting, The system setup menu 07, Speaker distance – Classe Audio VSX-80TXV User Manual
Page 39: Thx audio setting
The System Setup menu
07
39
En
3
Confirm your selected setup option.
The test tones will start after you press
ENTER
.
4
Adjust the level of each channel using
/
.
If you selected
Manual
, use
/
to switch speakers. The
Auto
setup will output test tones in the order shown on-
screen:
Adjust the level of each speaker as the test tone is
emitted.
1
5
When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• You can change the channel levels at any time by
using
EFFECT/CH SEL
and
+/–
on the remote control.
You can set two channel levels: one for
MULTI CH IN
and one for the listening modes.
Speaker Distance
For good sound depth and separation from your system,
you need to specify the distance of your speakers from
the listening position. The receiver can then add the
proper delay needed for effective surround sound.
1
Select ‘Speaker Distance’ from the Manual SP
Setup menu.
2
Adjust the distance of each speaker using
/
.
You can adjust the distance of each speaker in 0.5 foot
increments.
3
When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• For best surround sound, make sure the surround
back speakers are the same distance from the
listening position.
THX Audio Setting
For the most effective results when using the THX Select2
Cinema and THX MusicMode listening modes (see
Using
the Home THX modes
on page 27) with the Advanced
Speaker Array (ASA) system (see
About THX
on page 68),
it is required that you make the setting. See
THX speaker
system setup
on page 19 for more on THX speaker
placement.
2
1
Select ‘THX Audio Setting’ from the Manual SP
Setup menu.
2
Specify the distance of your surround back speakers
from each other.
•
0–1 ft
– Surround speakers within 1 foot apart (best
for THX surround sound).
•
1– 4 ft
– Surround speakers between 1 and 4 feet
apart.
•
4 ft <
– Surround speakers more than 4 feet apart.
3
When you're finished, press RETURN.
You will return to the Manual SP Setup menu.
Note
1 • If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level of each speaker to 75 dB
SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
4c.Channel Level
Test Tone
[ Manual ]
Please Wait . . .
20
Caution!
Loud test tones
will be output.
:Cancel
4c.Channel Level
L
0.0dB
C [
0.0dB
]
R [
0.0dB
]
SR [
0.0dB
]
SBR [ 0.0dB
]
SBL [ 0.0dB
]
SL [
0.0dB
]
SW [
0.0dB
]
:Finish
4.Manual SP Setup
:Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
e.THX Audio Setting
f.THX Speaker Setup
4d.Speaker Distance
L
10.0ft
(Reference)
R [
9.0ft
]
C
9.5ft
SL [
6.0ft
]
SR [
6.5ft
]
SBL [
6.0ft
]
SBR [
6.5ft
]
SW [
12.5ft
]
:Finish
2 If you don't have surround back speakers, or just have one, you won't be able to select this setting (
Cannot select
shows in the display).
4.Manual SP Setup
:Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
e.THX Audio Setting
f.THX Speaker Setup
4e.THX Audio Setting
SB SP Position
0-1 ft
SBL-SBR
:Finish
VSX-80TXV_KU.book.fm 39 ページ ２００６年３月１４日 火曜日 午後６時６分