Classe Audio VSX-80TXV - Manual (Page 66)

Additional information 12
66
En
HDMI
XM radio messages
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Other components can't be
operated with the system remote. • If the battery ran down, the preset codes may have been cleared. Re-enter the preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset codes.
The SR cable is connected, but
the connected components can’t
be operated with the remote. • Reinsert the SR cable, making sure it’s connected to the right jack (see Using this receiver with a Pioneer
plasma display on page 48).
• Make sure that there is an analog connection between the units. This is necessary for the SR feature to
work.
• Check that the other component is made by Pioneer. The SR feature only works with Pioneer equipment.
• Check that the IR receiver setting in
Multi-Room and IR receiver setup on page 53 is correct.
Symptom Remedy
Symptom Remedy
No picture or sound. • If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
No picture. • Depending in the output settings of the source component, it may be outputting a video format that can’t
be displayed. Change the output settings of the source, or connect using the component, S-video or
composite jacks.
OSD does not appear. • The OSD will not appear if you have connected using the HDMI output to your TV. Use component, S-
video, or composite connections when setting up the system.
No sound, or sound suddenly
ceases. • Since the HDMI audio signal is sent through this receiver to your TV, you need to make separate
connections for audio if you want to hear your HDMI component through this system. See
Connecting using
HDMI on page 42 for more on this.
• If you’ve made separate connections for audio, make sure you have assigned the analog/digital jack(s) to
the corresponding HDMI input for the component. See
Assigning the HDMI inputs on page 51 to do this.
• Check the audio output settings of the source component.
Symptom Cause Action
Check Antenna The XM antenna is not connected. Check that the XM antenna cable is attached securely.
XM ANT ERR A short-circuit occurring in the antenna or
surrounding antenna cable. Make sure that there is nothing unusual with the antenna or
antenna cable. Switch the power off then back on again.
Updating The radio is being updated with the latest
encryption code. Wait until the encryption code has been updated. Channels
00 and 01 should function normally.
No Signal The XM signal is too weak at the current location. n/a
Loading The receiver is acquiring audio or program
information. Wait until the information has been received.
Off Air The channel currently selected has stopped
broadcasting. Select another channel.
CH– – – You have selected a channel that does not exist,
or that you have not subscribed to. The receiver will automatically switch to channel 001 (or the
last selected channel).
– – – – – – – – There is no artist name/feature, song/program
title, or channel category associated with the
channel at this time. No action needed.
VSX-80TXV_KU.book.fm 66 ページ ２００６年３月１４日 火曜日 午後６時６分