COBY electronic DVD-958 - Manual (Page 10)

1.6 LAST MEMORY
ON: Each time you turn off the unit or stop the disc, it will memorize the last play time.
Next time you turn on the unit and play the same disc, the unit will play from that
memorized point.
OFF: Disable the last memory function.
2 AUDIO SETUP PAGE
There are eight items in the AUDIO SETUP PAGE. They are ANALOG AUDIO,
D I G I T A L A U D I O , D O L B Y D I G I T A L , C H A N N E L D E L AY, E Q U A L I Z E R , 3 D
PROCESSING and HDCD.
2.1 ANALOG AUDIO SETUP
2.1.1 DOWNMIX
LT/RT: The 5.1-channel audio is mixed into left channel and right channel and is
output via the FL and FR speaker respectively.
STEREO: The 5.1-channel audio is mixed into stereo signal and is output via the FL
and FR speaker.
3D SURROUND: This mode creates a virtual surround effect from stereo or multi-
channel audio contents.
5.1CH: Turn off the DOWNMIX mode. If a 5.1CH disc is playing or the unit is
connected to 5.1-channel amplifier, this item should be selected.
NOTE: This function only applies to the Dolby AC -3 encoded 5.1-channel discs.
2.1.2 FRONT, CENTER, REAR SPEAKER and SUB-WOOFER
Only when the DOWNMIX mode is turned off (DOWNMIX is set to 5.1CH), the
CENTER SPEAKER and REAR SPEAKER are activated. The FRONT SPEAKER can
be set to LARGE or SMALL. The CENTER SPEAKER, REAR SPEAKER can be set
to LARGE, SMALL or OFF and the SUBWOOFER can be set to ON or OFF.
NOTE:
If the speaker is set to LARGE, the output level will be higher than that of SMALL.
If the speaker is set to SMALL, the output level will be lower than that of LARGE.
If a speaker is set to OFF, no audio is outputted from it.
If the sound from your speakers is distorted, try setting the speaker size to SMALL.
2.1.3 DIALOG
When DOWNMIX is set to LT/RT or STEREO, this item is available.
Adjust the value of this item to control the dialog volume.
NOTE: When playing 5.1CH disc, this item can be used to adjust the volume of the
speakers.
2.1.4 D.R.C.(Dynamic Range Control)
You can set this item to ON, OFF or AUTO.
2.2. DIGITAL AUDIO SETUP
2.2.1 DIGITAL OUTPUT
SPDIF/ OFF: There will be no digital audio signal output. (Coaxial off)
ALL: The digital audio signal output will be in its raw format.
PCM only: The digital audio signal output will be in PCM format.
System Setup
-9-