PRG OHM User Manual 1.12 - Manual (Page 12)

10 OHM™ LIGHT USER MANUAL
Powering Options
Neutrik Power Cable Connector
OHM is fitted with a Neutrik PowerCon® NAC3 type
connector. Use only Neutrik PowerCon NAC3FCA connectors.
It is the user's responsibility to provide and wire their own
power cable using the Neutrik power cable connector
provided with OHM.
To wire connector:
Step 1. Slide bushing and chuck onto cable.
Step 2. Prepare cable as shown in Figure 1.
Step 3. Insert wire into terminals and fasten clamping
device using slotted screwdriver.
Step 4. Push insert and chuck into housing (pay attention to
the guiding keyway!).
Step 5. Fasten bushing by means of a fork wrench, 3/4" minimum. Torque 2.5 Nm (1.8 lb-ft).
Figure 1: Neutrik Power Cable Wiring
Accessory Options
Note: OHM-specific accessories are currently under development. Please contact your sales office for more info.
Accessory Skirts
Standard Space Light accessory skirts may be used with
OHM, if desired. These hang on the three accessory pillars
mounted on the chassis of the fixture.
ENGAGEMENT
SEPARATION
Da = 5.00 [0.197”] - 11.00 [0.433”]
white chuck
Da = 9.50 [0.374”] - 15.00 [0.59”]
black chuck
Housing Insert Chuck Housing