PRG OHM User Manual 1.12 - Manual (Page 8)

6 OHM™ LIGHT USER MANUAL
Additional Safety Considerations
1) Do not open OHM when the fixture is powered.
2) Allow OHM to cool before servicing, as internal parts may be hot.
3) Do not alter the design of OHM or tamper with any of the safety features.
4) Do not look directly into OHM's bare light source as it may be harmful to the eyes.
5) OHM reaches a maximum surface temperature of 85ºC. Please ensure contact on the surface by persons or
materials is avoided when the fixture is operating.
6) Do not operate OHM if there are any signs of physical damage. In case of damage, it is advised that you contact
PRG service.
7) Before using OHM check for any of the following defects:
Cleaning
1) Clean optical front plate with suitable alcohol-based cleaner.
Power Supply
1) Ensure the power cable is disconnected before servicing.
2) OHM only uses a mains connection. Do not connect to a variable supply, such as a dimmer rack or inverter.
3) The power cable should be plugged into OHM before switching the mains power supply ON. The mains power
supply should be switched OFF before removing the power cable.
Note: OHM has been built to conform to International regulatory standards relating to professional lighting
equipment. Any modification made to OHM will void the manufacturers' warranty.
PART POSSIBLE DEFECT
Optics Physical damage, dull, burnt out
Power Cable Physical damage, cut, burnt
Locking Handle Physical damage, loose
Spigot/Lifting Eye Physical damage, loose, crack/split
Hanger Assembly Physical damage, loose lifting eye
Hanger Assembly -
Cables/Carabiners
Physical damage, cut, frayed, carabiners loose or deformed
Safety Cable/s Physical damage, cut,
Ventilation Physical damage, covered
MMI Physical damage, unrecognizable screen
Yoke Physical damage, loose
Casing Physical damage