Transmitter battery installation, Transmitter controls, Miss geico 24 – Pro Boat PRB0500 User Manual

Page 6: Reverse switch

Advertising
background image

Miss Geico 24

Transmitter Battery Installation

This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Align the battery polarity with the markings in the

compartment and Install the batteries.

3. Install the battery cover.

Transmitter Controls

Battery Level Indicator

Solid Red and Green:

Battery voltage is

good (above 4V).
Solid Red: Battery

voltage is critically low

(below 4V). Replace

transmitter batteries.

Power Switch

Power on or off the transmitter

Steering Wheel

Control

steering.

Right and

Left steering

with ST. REV

Switch on N

(See ST. REV

switch)

Throttle Trigger

Controls power

to the motor

for forward

or reverse (See

TH. REV switch)

Stop

Reverse

(when TH.

REV switch

on R)

Forward

(when TH.

REV switch on R)

Adjusts the neutral

point of the electronic

speed control

Throttle Trim

Steering Rate

Adjusts the amount

the rudder moves

when the steering

wheel is turned

left or right

Adjust to make

the vehicle drive

straight with

no input at the

steering wheel

Steering Trim

Reverse Switch

Allows you to change the direction of

steering (ST. REV) and throttle (TH. REV)

controls. (Default settings are “R” for

steering and “N” for throttle) These

settings may change if the servo or ESC

are replaced.

Throttle Dual Rate

Adjusts the maximum

amount of throttle the

vehicle can be given

6

EN

Advertising