Pro Boat PRB08016 - Manual (Page 10)

Recoil 17
Problem Possible Cause Solution
Boat will not respond
to throttle but responds
to other controls
Throttle channel is reversed Reverse throttle channel on transmitter
Extra noise or extra
vibration
Damaged propeller, shaft or motor Replace damaged parts
Propeller is out of balance Balance or replace propeller
Reduced runtime or
boat underpowered
Boat battery charge is low Completely recharge battery
Boat battery is damaged
Replace boat battery and follow
battery instructions
Blocking or friction on shaft or propeller Disassemble, lubricate and correctly align parts
Boat conditions may be too cold
Make sure the battery is warm (above 10º C
(50º F)) before use
Battery capacity may be too low
for conditions
Replace battery or use a larger capacity battery
Drive dog is too near the stuffing tube
Loosen drive shaft side of the motor coupling and
move drive shaft small amount back
Too little lubrication on drive shaft Fully lubricate drive shaft
Vegetation or other obstacles block
the rudder or propeller Remove vegetation or obstacles from rudder or
propeller
Boat will not Bind
(during binding) to
transmitter
Transmitter is too near boat during
binding process Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Boat or transmitter is too close to large
metal object, wireless source or
another transmitter
Move the boat and transmitter to another location
and attempt binding again
Another compatible transmitter is
powered on within range of the
receiver
Power off all compatible transmitters
except the one you are trying to bind
Boat battery/Transmitter battery charge
is too low
Replace/recharge batteries
ESC switch is off Power on ESC switch
Boat will not connect
(after binding) to
transmitter
Transmitter is too near boat during
connecting process Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Boat or transmitter is too close to large
metal object, wireless source or
another transmitter
Move boat or transmitter to another location and
attempt to connect again
Boat battery/transmitter battery charge
is too low
Replace/recharge batteries
ESC switch is off Power on ESC switch
Boat tends to dive in
the water or takes on
water
The boat hull is not completely closed
Dry out the boat and ensure the hatch is fully
closed on the hull before returning the boat
to the water
Center of gravity is too far forward Move batteries back in the hull
Trim tabs are angled incorrectly
Angle each trim tab up a small amount to lift the
bow or down a small amount to lower the bow
Boat tends to turn one
direction
Rudder or rudder trim is not centered
Repair rudder or adjust rudder and rudder trim
for straight running when control is at neutral
Vertical fi ns are angled incorrectly
Adjust the right or left fi n angle for straight
running when control is at neutral
Troubleshooting Guide
10
EN