Pro Boat PRB08016 - Manual (Page 8)

Recoil 17
A
D
C
B
Trim Tab Adjustment:
Tip: Ensure the trim tab panels are parallel to the
bottom of the boat.
You may desire to bend the trim tabs for wind and water
conditions. To adjust the angle of the trim tabs, use a
large pair of pliers to bend the tabs. This must be done
carefully so that you do not damage the hull.
Trim Fin Adjustment
NOTICE: Carefully handle the sharp trim fins, which can
cause injury or damage.
1. Loosen and tighten the fins on the mount using a hex
wrench and a pair of pliers.
Tip: Ensure the trim fins are near a 45-degree angle on
the mount.
Rudder Trim
If the boat does not go straight, adjust the steering trim
dial on the transmitter.
If you are using all the steering trim on your transmitter
to make the boat drive straight, return the trim to neutral
and mechanically center the rudder. To do this, loosen
the hex nut (A) from the rudder horn (B), then adjust the
linkage (C) until the rudder is properly centered.
Rudder Service
1. Loosen the setscrew (A) on the rudder arm using a
1.5mm hex wrench, then remove the linkage (B) from
the rudder arm.
2. Loosen the setscrew (C) from the rudder pin (D) using a
1.5mm hex wrench.
3. Turn over the boat and lightly tap the rudder to
remove the pin.
4. Assemble in reverse order.
A
C
B
8
EN