PS Engineering PCD7100-P Pilot’s Guide - Manual (Page 3)

3 PCD7100-P Pilot Guide Rev. 2
1 2 3 4 5
1 (Play) Plays CD, push again to pause
2 (Next track) Push to jump to the next track, hold to fast
forward current track
3 (Previous track) Push to jump to the previous track, hold
to rewind current track
4 (Stop) Stops playback
5 (Eject) Ejects disc
The CD player will begin to play automatically when a CD is inserted.
Press the play button to pause the track.
The jump forward button advances to the next track. Jump backwards
selects the previous track. Stop ceases play, and Eject removes the disk
from the CD player.
Aural Warning System (P/N 11953, 11954 only)
When this option is installed, the PCD7100 contains six stored messages.
An outside annunciator, such as an engine gauge system, triggers these
messages. When there is an announcement, it will be repeated every two
seconds until the unit-mounted ACK button is pushed. This stops the
played annunciation, until the next announcement is required.
Creating MP3s on your home computer, from an Audio CD
Start MusicMatch JukeBox.( www.musicmatch.com ) Press the recorder button,
which is the small red dot located in the top right corner. This will open the recorder
window located at the bottom of the screen.
Insert an audio CD into your computer’s CD drive. MusicMatch will automatically
read the disc and display the contents in the recorder window. Press the REFRESH
button to check the Internet database for CD information, such as artist, song title,
or album. If this information is available, it will automatically be updated in the file.
Select Options->Recorder->Format and select either MP3 or MP3PRO format. You
may also set the MP3 file quality under the Options->Recorder->Quality menu.
N OTE:
For best results (reduced skipping, etc.) burn rate of the disc should not exceed
the published rate of the media, or 2X, whichever is lower .