Ram Trucks 2013 3500 - User Guide - Manual (Page 147)

5. Turn the wing bolt clockwise to secure to the floor pan. Reinstall the plastic cover.
2500/3500 Series Trucks
1. Tighten the jack all the way down by
turning the jack turn-screw clockwise
until the jack is snug.
2. Position the jack and tools into
bracket assembly. Make sure the lug
wrench is under the jack near the jack
turn-screw. Snap tools into bracket
assembly clips. Install the jack into
bracket assembly and turn screw until
jack is snug into bracket assembly.
3. Place the jack and tool bracket as-
sembly in the storage position holding
the jack by the jack turn-screw, slip
the jack and tools under the seat so that the bottom slot engages into the fastener
on the floor.
NOTE:
Ensure that the jack and tool bracket
assembly slides into the front hold down
location.
4. Turn the wing bolt clockwise to secure
to the floor pan. Reinstall the plastic
cover.
WHAT TO DO IN EMERGENCIES
145