RED OLPF FRAME - Manual (Page 8)

8 955-0011, Rev-A1 / COPYRIGHT © 2012 RED.COM, INC
OLPF FRAME INSTALLATION INSTRUCTIONS
InsTall The lens mounT
Make sure it is seated correctly
TIghTen The sCrews
Using a T-20 Torx Driver, seat the four Torx screws
very lightly until finger-tight.
After all four screws are seated; progressively tighten
them in an “X” pattern as shown until hand tight.
IMPORTANT: Tighten the screws snug but do not
over tighten. Torque the screws to 22 in-lbs if using a
torque driver.
InsTall The lens mounT