RED ONE 1.8 SSD MODULE - Manual (Page 11)

DECEMBER 28, 2010 ©2010 RED.COM, INC.
9
INSTALLATION VERIFICATION PROCEDURE
Verify proper operation of the RED ONE 1.8” SSD Module by performing the following:
1. Power up the RED ONE.
2. Insert a RED 1.8” SSD MAG into the RED ONE 1.8” SSD Module. “SLOW MEDIA” displays on the
Camera’s LCD and “Unformatted” displays in the lower left corner of the external display(s) until the
RED 1.8” SSD MAG is formatted.
o
If the camera does not recognize the SSD and continues to display “NO DIGIMAG” on the Cam-
era’s LCD and “None Attached” in the lower left corner of the external display(s), ensure you are
using an SSD approved by RED for use with the RED ONE. If the SSD is approved for use by RED,
recheck the RED ONE 1.8” SSD Module connections.
3. Format the RED 1.8” SSD MAG.
o
Press the SYSTEM button at the rear of the camera.
o
Navigate to the MEDIA menu.
o
Select FORMAT. “Disk Unformatted” will display on the Camera’s LCD.
o
Camera will format the RED 1.8” SSD MAG.
o
Select OK when complete.
4. When format is complete, verify operation by recording a test clip and playing it back using the con-
trols on the camera.
NOTE: Unmounting the RED 1.8” SSD MAG is the same as unmounting a Compact Flash (CF) card,
RED-RAID®, RED-DRIVE® and RED-RAM®.