RED ONE 1.8 SSD MODULE - Manual (Page 9)

DECEMBER 28, 2010 ©2010 RED.COM, INC.
7
INSTALLING RED ONE 1.8” SSD MODULE
1. Carefully connect the Serial ATA and e-SATA connectors to the RED ONE 1.8” SSD Module.
NOTE: Connectors are installed in the opposite direction as when connected to the CF Module.
2. Place the RED ONE 1.8” SSD Module on the RED ONE camera body.
CAUTION: Ensure the harnesses are not pinched or damaged during installation.
3. Install the existing Allen Screw Lock Washers (4) onto the NEW Allen Screws (4).
4. Install all four (4) Allen Screws and washers into the RED ONE 1.8” SSD Module finger-tight.
Carefully Plug In
Both Connectors
Install Allen Screws
and Washers