Cabletron Systems ESX-1380 - Manual (Page 63)

Selecting an Update-Freq
ESX-1320/ESX-1380 Local Management Guide 12-3
Out Octets
This field displays the number of octets (bytes) transmitted by the
interface.
Out Unicast Pkts
This field displays the number of unicast packets (packets destined for
one specific address) transmitted by the interface.
Out Nonucast
This field displays the number of non-unicast packets (multicast and
broadcast packets; packets destined for more than one address)
transmitted by the interface.
Out Discards
This field displays the total number of packets discarded by the interface
due to a lack of available resources.
Out Errors
This field displays the total number of errors for a given interface:
Update-Freq
Use this field to select the time interval between Network/Slot/Port
counter updates. You can select update intervals in increments of 3
seconds, with the maximum interval being 99 seconds.
Interface
This command field allows you to select the interface(s) you want to
monitor.
12.2 SELECTING AN UPDATE-FREQ
The ESX updates the Bridge Statistics screen every three seconds by
default. The UPDATE-FREQ command allows you to adjust the
frequency in intervals of 3 seconds. The maximum update frequency is 99
seconds.
To adjust the UPDATE-FREQ, perform the following steps:
1. Use the arrow keys to highlight the UPDATE-FREQ command field.