Crestron electronic CSP-LSP - Manual (Page 13)

Crestron CSP-LSP Lightning Strike Protector
Connectors, Controls & Indicators (Continued)
# CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
2 GROUND (2) 10-32 studs, chassis
ground lugs
2 ;
3 ft flat braided grounding strap
included;
Ground bus bar included for
daisy chaining to a second
CSP-LSP unit.
3 CONTROL SYSTEM (2) 4-pin 5mm detachable
terminal blocks;
Protected Cresnet ports,
paralleled, for connection to
control system and other
protected Cresnet devices.
1. Interface connectors for DEVICE and CONTROL SYSTEMS ports are
provided with the unit.
2. For maximum protection, terminate the CSP-LSP to a good earth ground (i.e.
utility ground, cold water pipe, or grounding rod) using the grounding strap
provided. The control system must also be grounded. It is also suggested that
devices connected to the DEVICE ports be powered separately from those
connected to the CONTROL SYSTEM ports. Consult the control system
manuals and refer to page 13 for additional information.
Operations & Installation Guide – DOC. 6643A Lightning Strike Protector: CSP-LSP • 9