Suggested for decnet, Wan interface configuration, Physical communications settings – Compatible Systems RIOP HSSI-10/100 User Manual
Page 11: Required for dedicated line operation, Suggested for dedicated line operation, Ppp configuration, Link configuration, Ip protocol, Required for ip, Suggested for ip
Chapter 2 - Quickstart Configuration
7
Suggested for DECnet
Setting the parameters above should be adequate for most installations.
WAN Interface Configuration
In order to use the WAN interface, you may want to set some physical parameters. Then set up
the link and protocol parameters.
Physical Communications Settings
Required for Dedicated Line Operation
No changes from the default values are required for standard operation over a T3 line. The
default values are listed in
.
Suggested for Dedicated Line Operation
Changing to a different clocking or CRC setting may be required. These parameters can only
be set using the command line interface.
TB: Use configure and the HSSI Interface WAN 0 section.
PPP Configuration
This section covers the settings required for PPP (point-to-point) protocol operation of the
HSSI WAN interface.
Link Configuration
Required for Dedicated Line Operation
This is the only mode of operation supported via the built-in HSSI CSU/DSU.
•
Set Dedicated connection
•
Set PPP connection
CV: Use the Link Configuration: WAN Dialog Box.
TB: Use configure and then set the Mode and ConnectMode keywords in the Link Config
WAN 0 section.
Suggested for Dedicated Line Operation
Dedicated line operation generally does not require additional parameters for operation.
IP Protocol
Required for IP
WAN interfaces which are set for PPP operation do not generally use an IP address. They are
set to act as an “unnumbered interface.” In this mode of operation, there are no required
settings.
Suggested for IP
These parameters help supply information about the segment that the interface is connected to.
With this information, routing can take place.
•
Set IP RIP 1, IP RIP 2, OSPF (Open Shortest Path First) or BGP (Border Gateway
Protocol)
•
Set IP static routes
CV: Use the TCP/IP Routing: WAN Dialog Box to set RIP, and the IP Static Routing Dialog
Box (under Global/IP Static Routes) to set static routes. OSPF and BGP can only be config-
ured using text-based configuration.