SIG SAUER SIGM400 Rifle - Manual (Page 18)

18 www.sigsauer.com
5. Bullets can become lodged in the barrel:
• If the cartridge has been improperly loaded without propellant powder, or if the powder fails to ignite (ignition of
the cartridge primer alone will push the bullet out of the cartridge case, but usually does not generate sufficient
energy to expel the bullet completely from the barrel);
• If the bullet is not properly seated in the cartridge case. When such a cartridge is extracted from the chamber
without being fired, the bullet may be left behind in the bore at the point where the rifling begins. Subsequent
chambering of another cartridge may push the first bullet further into the bore.
6. If there is any reason to suspect that a bullet is obstructing the barrel, immediately unload the firearm and look through
the bore. It is not sufficient to merely look in the chamber. A bullet may be lodged some distance down the barrel where
it cannot easily be seen.
IF A BULLET IS IN THE BORE, DO NOT ATTEMPT TO SHOOT IT OUT BY USING ANOTHER CARTRIDGE OR BY
BLOWING IT OUT WITH A BLANK OR ONE FROM WHICH THE BULLET HAS BEEN REMOVED. SUCH TECHNIQUES CAN
GENERATE EXCESSIVE PRESSURE, WRECK THE FIREARM, AND CAUSE SERIOUS PERSONAL INJURY.
If the bullet can be removed with a cleaning rod, clean any unburned powder grains from the bore, chamber, and
mechanism before resuming shooting. If the bullet cannot be dislodged by tapping it with a cleaning rod, take the firearm
to a gunsmith.
7. Dirt, corrosion, or other foreign matter on a cartridge can impede complete chambering and may cause the cartridge
case to burst upon firing. The same is true of cartridges which are damaged or deformed.
11SIG455_M400MiniManual.indd 18 8/2/11 3:58 PM