Snazzy FX MINI-ARK - Manual (Page 7)

time. Once again, results will vary depending on what MODE you are in on the Magical Selector, but it
is always great fun. Once again, in Gate mode, simply put the Magical selector all the way to the left
for “regular” tracking. If you hit a note you like, simply click on the STOMPSWITCH to allow the note
to freeze. You can then play over this note with the DRY signal and/or the HOLD signal (octave below)
14. OUT JACK
15. IN JACK (mono ¼” only)
16. DC IN JACK (use only 2.1mm 9volt center negative BOSS style adapter 200-650ma)
17.GATE OUT JACK: This jack puts out a signal to interface with ADSR'S or anything else you may
want to experiment with.
18.SQUARE OUT: This is a square wave out tapped off of the OCTAVE rotary. Use it for a second
output or as a SYNC out. (or even plug it into the FM in of a VCO) When using for SYNC effects with a
VCO, switch the GATE/SUSTAIN mode to SUSTAIN and plug this straight into your VCO or any other
device with a SYNC IN to get interesting effects. Set your VCO so that it is not too high or low, and
you will be able to play your VCO with your guitar. For best results, you may want to mix the audio
from the MINI-ARK with the audio from your VCO.
19.CV (ENV) OUT: This is a very basic (CV) out, which can be patched into anything with a CV input.
It’s effect is tied to dynamics, and this jack can be connected to the cutoff of a filter or the pitch of a