Solberg Vacuum Discharge Oil Mist Eliminators - Manual (Page 9)

Solberg International, Ltd., 1151 Ardmore Itasca, IL 60143 USA
Ph: +1 630.773.1363 • Fax: +1 630.773.2643 • Email: [email protected] • Web: www.solbergmfg.com
Oil Mist Exhaust Filters • Rev. MA4031103
Page 9
SOLBERG
C. Secure washer and thumb/wing/hex bolt to element top plate and tap bolt.
Element must be tightly secured. Note: Do NOT over tighten!
! WARNING !
Defective installation may cause system or
pump contamination. Use only genuine
Solberg replacement parts.
5. Securing canister/housing top to canister base.
A. Make sure all surfaces are free from dust and other particulate.
B. O-rings (where necessary) must rest evenly along canister/housing base o-ring
groove.
C. SV: Place canister top over element and twist top.
D. EF/EE: Place canisters top over element and insert and tighten thumbscrew.
E. Small HDL (2”-2 ½”): Secure V-clamp by disconnecting hex nut or T-bolt portion
and placing V-clamp along the diameter of canister o-ring groove. Fasten T-bolt
and secure tightly. V-CLAMP LEGS MUST REST UNIFORMLY ALONG ENTIRE
O-RING GROOVE. For smaller EE’s, simply twist canister top until top is in
resting position with tabs.
F. Large HDL: Replace housing top plate. Insert T-bolts into corresponding holes
and tighten evenly around perimeter. Note: Do NOT over tighten!
Section D
MAINTENANCE RECOMMENDATIONS
1. Initial back pressure readings are recommended to maintain an effective oil mist filter.
Always document initial back pressure during start-up when element is clean and
after two weeks when element is saturated. Replacement cartridge is needed when
system experiences high back pressure. Refer to page 6 for guidelines.
2. Always check replacement O-rings to insure they are seated uniformly along the
canisters/housings during installation. If O-rings do not seat properly or are damaged
in some manner, contact Solberg Manufacturing, Inc. immediately. Do not modify or
change O-rings!