Soniclean UW3000 - Manual (Page 8)

4.1.4. Start Cleaning:
i)
Close the lid and press “CLEAN”
ii) The machine will perform a cleaning cycle according to its program.
Iii) The following table explains the various parameters of the clean
function, which are displayed during cleaning and are programmable to suit
your requirements.
Cleaning
Activity
Display Parameters set by
manufacturer
(Settings)
Explanation
Clean No. C-01 10 Current Cleaning cycle
number
Ultrasonics P-03 3 Displays power level
Time
Remaining
03.48 5 minutes Time remaining to
complete current clean
cycle shown in minutes
and seconds.
4.1.5 To Pause Cleaning:
i)
Lift the lid to pause the cleaning cycle.
ii) This feature allows for any adjustments the instruments may require.
4.1.6 To Stop Clean Cycle:
i) Press “CLEAN” again during cycle. This will stop cycle and clear
current clean.
ii)
To start new cycle press “CLEAN” again.
4.1.7 Completion of Single Clean Cycle:
i)
The machine, will emit 5 beeps and display ‘- - - -‘.
ii) Lift the lid.
Iii) Raise the instrument tray and transfer to rinse tank.
4.1.8 Automatic Drain and/or Shutdown:
The Washer can be programmed to automatically drain after a selected
number of cleaning cycles.
i) Manufacturer’s programmed number of cleans between draining is ten.
ii) When the tenth clean cycle is completed the machine will display
“END”.
iii) The tank will automatically drain.
iv) To refill the tank press 'shift' & 'refill' together for 3 seconds.
v) Washer will be ready for reuse when '--.--' is displayed.
UW-3000 Washer Operating Manual Page 8 of 24
© Soniclean Pty Ltd Version 2.0 April 2009