Sonics E-Press - Manual (Page 4)

Sonics E-Press Manual Page 4
INSPECTION
Prior to installing the equipment, perform a visual inspection to detect any evidence of damage which might
have occurred during shipment. Before disposing of any packing material, check it carefully for small items.
The equipment was carefully packed and thoroughly inspected before leaving our factory. Responsibility for
its safe delivery was assumed by the carrier upon acceptance of the shipment. Claims for loss of damage
sustained in transit must therefore be made upon the carrier, as follows.
CONCEALED LOSS OR DAMAGE -
Concealed loss or damage means loss or damage which does not
become apparent until the merchandise has been unpacked. The contents might have been damaged in
transit due to rough handling even though the container may not show external damage. When the damage is
discovered upon unpacking, make a written request for inspection by the carrier’s agent within 48 hours of the
delivery date. Then file a claim with the carrier since such damage is the carrier’s responsibility. The form
required to file such a claim will be supplied by the carrier. Do not destroy packing materials, or move material
from one location to another before the carrier makes their inspection.
VISIBLE LOSS OR DAMAGE
- Any external evidence of loss or damage must be noted on the freight bill or
express receipt, and signed by the carrier's agent. Failure to adequately describe such external evidence of
loss or damage may result in the carrier's refusal to honor a damage claim. The form required to file such a
claim will be supplied by the carrier.
If the system or any unit is damaged, contact the Sales Department at Sonics & Materials, Inc. “Sonics” will
arrange for repair or replacement of damaged equipment without waiting for the claim against the carrier to be
settled, provided a new purchase order is issued to cover the repair or replacement costs. Should any
damage, shortage or discrepancy exist, please notify us immediately.
ELECTRICAL POWER
The E-Press motor controls require a fused, single phase, standard 3-terminal grounding type electrical
receptacle capable of supplying 105-125 volts, 50/60 Hz, 10 amp service, or 200-240 volts, 50/60 Hz, 5 amp
service, depending on the voltage option. See the Model Specification and Accessory List – section 3.0.
MODEL @ 115 VAC @ 230 VAC
20EP or 40EP 10 amps 5 amps