Speeco LS401105H - Manual (Page 10)

ENGINE OIL RECOMMENDATIONS
SpeeCo 6.5 HP
Use 4-stroke automotive detergent oil. SAE 10W-30 is recommended for general use. Refer to the SAE Viscosity Grades chart on page 17 of your engine
owner’s manual for average temperature ranges. The engine manufacturer recommends using API SERVICE Category SE or SF oil.
The engine oil capacity is 0.63 US qt (0.6 L).
Always check oil level before starting the engine. Keep oil level at full.
Honda GC190
DIRECTIONS FOR FILLING HYDRAULIC SYSTEM
Fill the hydraulic reservoir with at least two gallons of hydraulic fluid. After the hydraulic reservoir and the engine crankcase are filled with oil, start the
engine. The hydraulic pump should prime itself. With the engine running, move the hydraulic valve lever toward the wedge. This will cause the cylinder to
extend and expel air. When the cylinder is fully extended, retract it. Repeat this procedure several times. An erratic movement of the cylinder indicates that
there is still air in the system. More oil should then be added to bring the fluid level up to the “OK” range on the dipstick. Total hydraulic capacity is 2.5
gallons. NOTE: If the tank is overfilled, it will tend to expel oil from the breather cap when the cylinder is retracted. After adding more oil to the tank, cycle the
cylinder again until it has a constant speed indicating that all oil has been expelled. Check the oil level in the reservoir again to make sure it is in the “OK”
range.
STARTING INSTRUCTIONS
SpeeCo 6.5 HP
NOTE: REFER TO THE ENGINE OWNER’S MANUAL FOR COMPLETE INFORMATION ON STARTING, MAINTENANCE AND TROUBLE-
SHOOTING.
1) Move the fuel valve lever to the ON position.
2) To start a cold engine, move the choke lever to the CLOSE position.
To restart a warm engine, leave the choke lever in the OPEN position.
3) Move the throttle lever away from the SLOW position, about 1/3 of the way toward the FAST position.
4) Turn the engine switch to the ON position.
5) Pull the starter grip until you feel resistance, then pull briskly. Return the starter grip gently.
6) If the choke lever has been moved to the CLOSE position to start the engine, gradually move it to the OPEN position as the engine
warms up.
7) To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal conditions, move the throttle lever to the
SLOW position and then turn the engine switch to the OFF position. Then turn the fuel valve lever to the OFF position.
For further information on starting and stopping the engine, refer to your engine owner’s manual.
Honda GC 190
Page 8
For temperatures above 50 degrees F, use an SAE 30W oil. Using multigrade oil may increase oil consumption. For temperatures below 50 degrees F use
and SAE 10W-30 oil. Using SAE 30W oil below 40 degrees F will result in hard starting and possible engine bore damage due to inadequate lubrication. SAE
10W-30 is recommended for general use. Refer to Honda engine owner’s manual. Oil capacity is 0.56 quart
(18 ounces; 0.53 liter).
Always check oil level before starting the engine. Keep oil level at full.
NOTE: REFER TO HONDA ENGINE OWNER’S MANUAL FOR COMPLETE INFORMATION ON STARTING, MAINTENANCE AND TROUBLE-
SHOOTING.
To Start a Cold Engine
1) Turn the fuel valve to the ON position.
2) Move the choke to the ON position.
3) Move the throttle control to the FAST position.
4) Pull the starter grip lightly until resistance is felt. Then pull rapidly to start engine.
5) Move the choke lever to the OFF position if it was used to start the engine as soon as it warms up enough and is running smoothly.
6) When engine starts, move the throttle to the FAST position. It is recommmended that the engine be operated in the FAST position for
maximum performance.