Speeco LS401105H - Manual (Page 11)

1) Set up the log splitter in a clear, level area and block the wheels. Make sure that the suction port on the tank is always on the lower side
of the log splitter.
2) Place a log on the beam against the wedge. Make sure that the log is securely on the wedge and up against the beam. Always use
extra care when splitting logs with unsquare ends.
3) Depress the valve handle so that the cylinder will drive the ram into the log. Extend the cylinder until the log splits or to the end of its
stroke. If the log has not completely split after the cylinder has reached the end of its extension, retract the cylinder.
IMPORTANT: Leaving the valve in the “actuate” position at the end of the stroke may damage the pump.
NOTE: Output tonnage varies with altitude.
MAINTENANCE
1) Consult the operating and maintenance instructions of the engine manufacturer for engine care and maintenance.
2) Always check the oil level of the hydraulic reservoir before operation. Operating the log splitter without an adequate oil supply will
cause severe damage to the pump.
3) Change the oil filter after the first 25 hours of operation. Thereafter change the oil filter every hundred hours or seasonally, whichever
comes first.
5) Clean the breather cap after 25 hours of operation. Clean it more often when operated in dusty conditions. To clean, remove the breather
from the tank and flush with kerosene or liquid detergent to remove the dirt.
6) See also Repair and Maintenance Safety in the Safety Information section of this manual.
7) All replacement parts must meet manufacturer’s specifications.
Page 9
To Start a Warm Engine
1) Move the throttle lever to the FAST position.
2) Leave the choke lever in the OFF position.
3) Pull the starter grip until the engine starts.
To Stop the Engine
1) Move the throttle lever to the SLOW position.
2) Move the throttle lever to the STOP position.
3) Turn the fuel valve to the OFF position.
The log splitter is equipped with pneumatic tires, a Class I coupler (2 in. diameter ball required) and safety chains. Before towing, the safety chains must be
secured to the hitch or bumper of the vehicle. Local regulations should be checked regarding licensing, lights, towing, etc. See also towing safetyin the safety
information section of this manual. Do not exceed 45 mph when towing this log splitter.
NOTE: The engine maximum governed speed is preset at the factory at 3600 RPM no load speed. When splitting wood, the throttle should be
set at the maximum setting to develop the horsepower required for the pump.
WARNING: ALWAYS WEAR SAFETY GLASSES WHEN OPERATING THIS LOG SPLITTER.
DANGER: KEEP HANDS AND FEET CLEAR OF RAM, STRIPPER PLATES AND BASE PLATE AT ALL TIMES.
TOWING
OPERATION