StarTech.com SDOCK2U33RE - Manual (Page 7)

Instruction Manual
4
Drive Installation
1. Carefully align and insert the 2.5” or 3.5” SATA drive(s) you wish to dock in the
desired hard drive slot on the docking station, such that the SATA power and data
connectors on the drive are properly aligned with the corresponding connectors
inside the hard drive slot.
Note: If connecting drives for duplication, the drive containing the DATA you intend
to be copied, should be placed in the Source bay (Hard drive #2 slot). While the drive
you intend to have the DATA copied to should be placed in the destination bay
(Hard drive #1 slot).
2. Press the power button so the docking station is turned on.
Drive Removal
WARNING! Ensure your hard drive(s) has been disconnected from your computer
operating system prior to attempting drive removal. Failure to properly disconnect
your drive may result in lost data or drive damage. (See Disconnecting the Hard Drive
in Docking Station Operation for further instructions.)
1. Turn off the docking station by pressing the power button.
2. Press the eject button that corresponds with the drive you wish to remove.
3. Carefully grasp the ejected drive and lift it upwards until the bottom of the drive
has completely risen above the hard drive slot.
4. Safely and carefully store your drive in a secure location. (See your hard drive
manual for proper storage instructions.)