Cobra Digital DC4330 - Manual (Page 2)

1
Preface
Please read this manual carefully before any operation
This Manual covers all proper way of operation of the camera and relevant important notes. We sincerely
hope that you read this manual carefully so as to operate the camera properly. 20 minutes’ reading may save
you a lot of time.
Special attention: Taking compatibility of SD/MMC card into consideration, you must carry this camera to
test the SD/MMC card should you need to buy extra SD/MMC card from thirty parties. Buy SD/MMC card
that is compliant with this camera only.
A. Working condition
Temperature: 0°~45°
Relevant humidity: 45%~80%
Air Pressure: 56Kpa~106Kpa
B. Security Precaution
Please do not attempt any method to modify the camera. Otherwise fire, hurt, electric shock or
damage to the camera may be caused.
When working under sharp light, do not point the lens straight to sharp light or take a photo,
otherwise the image sensor component may be damaged.
Never fire the flash while it is too close to the subject’s eyes. Intense light from the flash can
cause eye damage if it is fired too close to the eyes. This is especially true with young children.
When using the flash, the camera should be at least one and a half meters from the eyes of the
subject.
Do not take photos where there is explosive, which may increase the danger of explosion.
Keep the small parts and accessories of this camera out of reach of small children to prevent
accidents.
Keep away from moisture to prevent damage caused by short circuit.
Never load leaking or wet battery into the camera. Any accessory attached to camera should not
carry water. In case that any liquid goes into the camera, please stop using and power off the
camera immediately.
Do not touch the camera with wet hands to avoid electric shock.
Operation in high electromagnetic condition is prohibited.
Try not to store the camera for too long time. Battery should be taken off for storage.
Do not place the camera under high temperature (such as well-closed car or under sharp sunlight)
or under unstable temperature. Exposure to high temperature may do harm to the internal
components and may cause fire to camera.
Try not to unplug the USB cable when transfer of file is in progress, otherwise data lose may be
caused. Furthermore, the USB port may be damaged or hang of computer may be caused.
When the camera is working, please place the camera in a closed space because over-heated
environment may damage the shape of camera or cause fire.
Before putting the camera into package, please make sure that all accessories like cables are
detached, otherwise damage may be caused to cable, and fire or electric shock may be caused.
We are not responsible for any damage or loss caused by illegal operation.