Studiologic Studio 90 plus - Manual (Page 13)

25
STUDIO 90 Plus
24
STUDIO 90 Plus
STUDIO 90 PLUS
PLUS 1
Param. Value Prog. Enter
2 3 4 5
6 7 8 9 0
Thank you for purchasing the FATAR Studio-90 Plus, the finest feeling master controller on the
market today. The action is a result of many years of engineering that went into the keyboard
mechanism. There are actually hammers that strike a surface that simulates a piano string.
The FATAR Studio-90 Plus master controller is very simple to operate once you understand its
capabilities. Even though the controller seems to be always in split mode, you can layer or split
one, two, or three sounds across the entire length of the keyboard. However, you must be aware of
the specific use of each parameter to get the desired results.
FEATURE LIST:
The following is a feature list of the ST-90 Plus master keyboard controller.
Power Supply: 9 VDC 500mA
88 Note Weighted Hammer Action Keys
Key measurements like a real piano
Dynamic Range (00-99)
Velocity Sensitivity Release (00-99)
Three Zones Programmable
Half-tone transposition
Octave transposition
Three MIDI Outputs
Foot-Switch Control
Program Change Footswitch
Pitch and Modulation Wheels
Outputs on all 16 MIDI Channels (three channels at one time)
100 Performance Programs (00-99)
Two digit numeric display
Beautiful Cabinet Design
Also available in sturdy case road case
The Studio-90 Plus can be supplied with a road case or with a beautiful designed
cabinet. All the functions are the same, but cosmetically they are quite different.
The following will explain the difference between the two regarding the back
pannel.
Look at figure #1. It shows the back panel of the ST-90 Plus built into a road case.
Note its three midi outputs. Each output sends out identical information. You can
connect four midi sound sources per output, giving you up to twelve sources to
choose from. NEVER CHAIN MORE THAN FOUR MIDI DEVICES PER OUTPUT,
THIS CAN CAUSE SOME DELAYS. If you need more outputs, purchase a thru-box.
Located to the right of the midi outputs you will find a 1/4" phone input jack for a
foot switch sustain pedal. We recommend a Music Industries PS-10 or a VFP-10
(optional) sustain pedal for this application. We will review the sustain capabilities
later on in the next section. To the right of the sustain jack is another 1/4" phone
input jack for program advance. You will also review this function later on.
Located to the right of the 1/4" jacks you will find the power switch. To the right of
power switch is the three pole line cord input and finally the fuse holder. Use a 1
AMP 250V GGS 5 X 20mm when replacing the fuse.
CONNECTIONS:
fig. #1
MIDI OUT
2 3
FOOT-SWITCH
MIDI
CONTROL
PROGRAM
CHANGE
POWER
ON
OFF
MIDI OUT 1
MIDI OUT 2
MIDI OUT 3
FOOT-SWITCH MIDI CONTROL
FOOT-SWITCH PROGRAM CHANGE
POWER
1
9V DC 200mA
LED
INPUT VDC