SunBriteTV 4660HD - Manual (Page 15)

SunBriteTV Model 4660HD Operator’s Manual Page 15
TV Installation – Rear Panel Connections
CONNECTINg TO A SATEllITE OR CABlE SET-TOP BOX (Continued)
1. Make sure the power of the TV and your set-top box is
turned off.
2. Obtain an S-Video Cable. Connect the S-Video connector
to both your set-top box and Composite’s S-Video
connector port off the back of your TV.
3. Obtain a RCA Audio Cable. Connect the white color
connector to both your set top box and Composite’s
white connector port off the back of your TV.
4. Connect the red color connector to both your set top box
and Composite’s red connector port off the back of your
TV.
5. Turn on the TV and your set top box.
6. Use the remote control’s source button or the source
button on the right side of the TV to switch to AV1
(S-Video).
Please Note :
1. If AV 1 is already occupied, use AV 2 as your connection
port and switch source to AV 2 (S-Video).
2. Refer to the set-top box’s manual to make sure the set-top
box is configured to output correctly to the TV.
3. This SunBriteTV model supports SONY’s universal remote
code. If SunBriteTV is not listed in the manufacturer list,
look up SONY’s codes in your universal remote’s hand
book.
4. This TV will turn off automatically if there’s no signal
present for more than 15 minutes.
1. Make sure the power of the TV and your set top box is
turned off.
2. Connect a Yellow Video connector to both your set top box
and Composite’s Yellow Video connector port off the back of
your TV.
3. Connect a white color connector to both your set top box
and Composite’s white connector port off the back of your
TV.
4. Connect the red color connector to both your set top box
and Composite’s red connector port off the back of your TV.
5. Turn on the TV and your set top box.
6. Use the remote control’s source button or the source button
on the right side of the TV to switch to AV1 (CVBS).
Please Note :
1. If AV 1 is already occupied, use AV 2 as your connection port
and switch source to AV 2 (S-Video).
2. Refer to the set-top box’s manual to make sure the set-top
box is configured to output correctly to the TV.
3. This SunBriteTV model supports SONY’s universal remote
code. If SunBriteTV is not listed in the manufacturer list, look
up SONY’s codes in your universal remote’s hand book.
4. This TV will turn off automatically if there’s no signal present
for more than 15 minutes.
Connecting with S-Video (Fair)
Connecting with
Composite (Fair)