SunBriteTV SB-WM46NA - Manual (Page 6)

SB-WM46NA Installation Instructions
6
ASSEMBLY and INSTALLATION
INSPECT MOUNT BEFORE ASSEMBLY
1. Carefully inspect the mount components for shipping
damage.
2. If any damage is apparent, call your carrier claims agent
and do not continue with the installation until the carrier has
reviewed the damage.
NOTE: Read all assembly instructions before starting the
installation process.
Wall Plate Installation
IMPORTANT ! : The SB-WM46NA mounts are designed to be
mounted to a 2" x 4" wood studs (16" or 24" on center) wall.
WARNING: It is the responsibility of the installer to verify
that the structure to which the mount is anchored will safely
support five times the combined load of all attached
components and equipment.
1. Determine a suitable mounting location and lift the wall plate
(A) into mounting position on wall.
2. Using a small nail or screw (not provided) in the center hole,
lightly support the wall plate at the mounting location. (See
Figure 1)
3. Level the wall plate (A) and drill 7/32" pilot holes for
anchoring the wall plate. (See Figure 1)
4. Using four 5/16 x 2 1/2” lag bolts (D) and four 5/16” washers
(E), install the wall plate on the wall. (See Figure 1) and
(See Figure 2)
Figure 1
Figure 2
5. Slide the latches on the wall mount to the outside in
preparation for installing display. (See Figure 3)
Figure 3
(R
16" studs installation
(D) x 4 4
3
7/32"
(E) x 4
x 4
(A)
(D) x 4 4
3
7/32"
(E) x 4
x 4
24" studs installation
(A)
5
5