SunBriteTV SB-WM46NA - Manual (Page 7)

Installation Instructions SB-WM46NA
7
Interface Bracket Installation
IMPORTANT ! : Interface brackets (B and C) are shipped
factory assembled to mount the SunBriteTV® 4600 and
5500-Series all-weather outdoor LCD televisions. If
mounting a SunBriteTV® 6500-Series television, long
interface brackets (G) must installed to brackets prior to
installing brackets to display.
Re-assembling Interface Brackets (6500-Series only)
1. Remove hex nuts from interface brackets (B and C) to
disassemble brackets. Set aside hardware and hanging
brackets to be used in re-assembly. (See Figure 4)
Figure 4
2. Replace short interface brackets with long interface
brackets (G) and re-assemble brackets using hex nuts and
screws. (See Figure 5)
Figure 5
Installing Interface Brackets to Display
1. Place display face down on a soft, non-abrasive surface.
2. Remove four sets of bolts and washers that were shipped
attached to the back of the display. Set hardware aside for
re-use. (See Figure 6)
WARNING: The bolts and washers are designed to be
permanent fixtures on the television. Never remove the bolts
or washers except for installation of the wall mount! Always
replace bolts immediately. Installing the television without the
bolts and washers may result in serious personal injury and/
or damage the television!
Figure 6
3. Place left and right interface brackets (B and C) on the back
of the display, with the tension knob on each bracket facing
toward the outside of the television. Place top of interface
brackets just below intake vent on back of display. (See
Figure 7)
Figure 7
x 2 1
(B)
(C)
(G) x 2
2 x 2
2 x 4
just below intake vent
knobs to the outside