Sure Heat Tuscany CS812 Natural Gas Conversion Kit - Manual (Page 2)

Be sure gas supply is off, the knobs are in the off
position and the grill is cool.
Wear a golve to be protected from the sharp
edges of the interior parts
To get started, remove all the control knobs and
set aside.
NOTE: Make sure to use supplied pipe sealant on
all non-flared fittings.
1. Use a 3/4” wrench disconnect the hose from the
side burner valve and pull the hose back into the
cart. (See Fig. 1)
2. Use a 3/4” wrench disconnect the other hose from
the manifold.(See Fig. 2)
3. Disconnect the igniter wires underneath the side
burner shelf. Then unscrew the push button cap on
the side burner shelf control panel, take out the
battery and unscrew the plastic nut to remov igniter
module.(See Fig. 3)
4. Loosen the four (4) hex head screws on the right
side of grill head assembly under the side burner
shelf for approximate 0.5” . Then lift and take off
the side burner shelf and set aside.(See Fig. 4)
5. Loosen the four (4) hex head screws on the left
side of grill head assembly under the left side shelf
for approximate 0.5” . Then lift and take off the left
side shelf and set aside.(See Fig. 5)
2
Tools Needed:
Phillips head screwdriver
3/4” wrench
1/4” wrench or socket
Adjustable wrench
Fig 3
Fig 4
Fig 5
CS812 Natural Gas Conversion Instructions
Hex Head Screws
Plastic Nut
* 1/4” socket set with extension can also be used.
Fig 1
Fig 2
Hex Head Screws
Side burner
valve elbow
Side burner
valve hose
Regulator
Hose