Sure Heat Tuscany CS812 Natural Gas Conversion Kit - Manual (Page 3)

6. Remove the four (4) phillips pan head screws
at both sides of the the front control panel.
(See Fig. 6)
7. Let a friend help you to pull the front control
panel away from the grill and hold it. Using a
wrench, hold the elbow on the rear IR burner
valve and use another wrench to disconnect
the flex line. (See Fig. 7)
8. Take off the front control panel, use a screw
driver to remove the eight (8) screws securing
the bezels and the manifold in position.
(See Fig. 8)
9. Replace the LP manifold with the one provided
in the NG conversion kit. Use the eight screws
removed in step 8 to attach the bezels and
manifold onto the front control panel.
NOTE: Make sure the “ OFF” position facing up as it
was.
10.Attach the front control panel onto the grill
head assembly by insert the extended tube of
the manifold into the large slotted hole on the
grill head bottom. (See Fig. 9)
11. Let a friend help you to hold the front control
panel and attach the rear IR burner flex line to
the rear IR burner control valve. (See Fig. 10)
12. Hold the elbow on the rear IR burner valve
and use a 3/4 wrench to tighten the flex line on
it. (See Fig. 7)
Note: Be careful, applying pressure to the elbow of
the valve may cause it to break.
3
Fig 8
Fig 9
Fig 10
Fig 7
CS812 Natural Gas Conversion Instructions
Fig 6
Phillps pan
head screws
Elbow on
the vale
Flex line
Hold this
elbow
Elbow on
the vale
Flex line