Chicago Electric WELDING SYSTEMS 91214 - Manual (Page 2)

Page 2 For technical questions, please call 1-800-444-3353. Auto-darkening
Welding Helmet
SAVE THIS MANUAL
Keep this manual for the safety
warnings and precautions, assembly,
operating, inspection, maintenance and
cleaning procedures. Write the product’s
serial number in the back of the manual near
the assembly diagram (or month and year of
purchase if product has no number). Keep
this manual and the receipt in a safe and dry
place for future reference.
IMpORTANT SAFETY
INFORMATION
In this manual, on the labeling, and
all other information provided with
this product:
This is the safety alert
symbol. It is used to alert
you to potential personal
injury hazards. Obey all
safety messages that
follow this symbol to avoid
possible injury or death.
DANGER indicates a
hazardous situation
which, if not avoided, will result
in death or serious injury.
WARNING indicates
a hazardous
situation which, if not avoided,
could result in death or serious
injury.
cAUTION, used with
the safety alert
symbol, indicates a hazardous
situation which, if not avoided,
could result in minor or
moderate injury.
NOTIcE is used to
address practices
not related to personal injury.
cAUTION, without
the safety alert
symbol, is used to address
practices not related to
personal injury.
SAFETY WARNINGS AND
pREcAUTIONS
WARNING: When using helmet, basic
safety precautions should always
be followed to reduce the risk of
personal injury and damage to
equipment.
The warnings, cautions, and instructions
discussed in this instruction manual
cannot cover all possible conditions and
situations that may occur. It must be
understood by the operator that common
sense and caution are factors which
cannot be built into this product, but
must be supplied by the operator.
Read all instructions before using
this helmet!
Do not use the Welding Helmet if 1.
the lens is cracked, if the lens or
sensors are dirty, or if the lens or
front retaining frame is loose.
Keep work area clean
2. . Cluttered
areas invite injuries.
Observe work area conditions
3. . Do
not use welding helmets in damp or wet
locations. Do not expose to rain. Keep
work area well lit. Do not use auto-
darkening helmets in the presence of
flammable gases or liquids.
Keep children away
4. . Children must
never be allowed in the work area. Do
not let them handle this helmet.
Store idle equipment
5. . When not in
use, helmets must be stored in a dry
location to inhibit rust. Always lock
up helmets and keep out of reach of
children.