Crimestopper Security Products RS-00 - Manual (Page 18)

18
OPTION DESCRIPTIONS
2. Auto Lock Unlock:
The option controls whether the doors will automatically lock/unlock on your vehicle when driving or with turning the
Ignition ON/OFF. If the Auto Lock feature is turned on, and the system is in Tach mode, then the doors will lock as the
engine RPM’s increase (driving). If the Auto Lock feature is turned on, and the system is in Smart Tachless mode, then
the doors will lock when the Ignition is turned on. When the Auto Lock feature is turned on, the system will unlock the
doors when the Ignition is turned off. With this feature OFF, the system will not automatically lock or unlock the vehicle.
3. Door Lock Pulse Time:
Controls the amount of time for lock/unlock pulse. The standard setting is 0.5 for most vehicles. A 3 sec. setting is
required for 1980’s/90’s European Vacuum or Pneumatic door lock systems.
4. Double Unlock Pulse:
The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing this
alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some Chrysler,
Nissan, VW, Toyota, and Lexus vehicles.
5. Data Port Protocol:
This option controls the Data Port Protocol for OFA Series modules or SL Series modules. The default is set for SL Series
Protocol. This option has no effect on conventional wiring of Bypass modules. Both OFA series and SL series are now 2-
Way Protocol.
6. Remote Start & Auxiliary Output – Button Press Selection:
To eliminate the possibility of accidentally opening the trunk or starting the vehicle, there are (3) options for button press
selection. This option will allow you to change whether the Remote starter and Trunk release activate by a:
4. Double button - ½ second presses.
5. Single ½ second press.
6. Press and Hold 2 seconds.
7. Horn Chirps on Remote Start:
This option allows the unit to provide 3 short chirps for audible confirmation of a remote start. The horn output wire must be
connected for this feature.
8. Lock During After Remote Start:
This option controls whether the unit will automatically lock during and after a remote Start abort or time-out.