6 screen send function – Casio fx-9750G PLUS User Manual
Page 436
408
21-6 Screen Send Function
The following procedure sends a bit mapped screen shot of the display to a
connected computer.
u
u
u
u
u
To send the screen
P.402
1. Connect the unit to a personal computer or to a CASIO Label Printer.
P.403
2. In the data communication main menu, press 6 (IMGE) and the following
display appears.
• {
OFF} ... {graphic images not sent}
• {
MONO}/{COLR} ... {monochrome}/{color} bitmap
• {
ON} ... bitmap
3. Press a function key to specify either “Monochrome” or “Color” for the Image
Set Mode.
4. Display the screen you want to send.
5. Set up the personal computer or Label Printer to receive data. When the other
unit is ready to receive, press M to start the send operation.
P.403
• Selecting “Monochrome” for Image Set allows data to be sent to any CASIO
Label Printer equipped with data communications capabilities.
Selecting “Color” allows data to be sent to Color Label Printer models only.
You cannot send the following types of screens to a computer.
• The screen that appears while a data communication operation is in progress.
• A screen that appears while a calculation is in progress.
• The screen that appears following the reset operation.
• The low battery message.
• The flashing cursor is not included in the screen image that is sent from the
unit.
• If you send a screen shot of any of the screens that appear during the data
send operation, you will not be able to then use the sent screen to proceed
with the data send operation. You must exit the data send operation that
produced the screen you sent and restart the send operation before you can
send additional data.
• You cannot use 6mm wide tape to print a screen shot of a graph.
* The above shows the CFX-9850
GB PLUS screen.
CFX
fx-9750G
PLUS
CFX
CFX