Carson LCS-7-01 - Manual (Page 7)

TB0349A Page 7 of 12 09/22/05
Light Control Connections
In addition to these instructions a label located on the bottom of the unit shows the light control switch connections.
Fuses / Breakers
The lighting control circuits of this unit are not fused. Automotive fuses or circuit breakers must be connected
between the power source and the unit properly rated for the circuit requirements. Failure to install proper circuit
breakers or fuses can result in damage to the unit and/or vehicle.
Lever Switch Connections
The following diagram shows proper connection of the lever switch leads located at the rear.
Note: Negative (NEG) connection must also be made on 10-Pin connector for proper operation.
YEL
GRN
BLU
RED
Circuit Breaker
or Fu se
60 AMP Max.
LOAD 1
LOAD 2
LOAD 3
+
BATT
-
Recommended
Wire Size
Amps Size
5 - 10 #16
10 - 15 #14
15 - 25 #12
25 - 40 #10
40 - 60 #8
60 - 80 #6
Use next larger size
if longer than 10 ft.
Lever
Position
Turns
On
Off All off
1 Load 1 only
2 Loads 1 and 2
3 Loads 1, 2 and 3
Off 1 2 3