Tactic TTX610 6-Ch SLT - Manual (Page 14)

14
● Do not allow chemicals to come in contact with any parts of the radio system. Substances such as glow
fuel, gasoline, CA glue, etc. could permanently damage plastic parts of the radio system.
● If rechargeable batteries were installed in the Tx, remove the batteries before placing the radio in long-
term storage.
RANGE IS SHORT: Interference – check Rx installation. Weak Tx or Rx battery – replace the batteries or
recharge as applicable. Rx may need to be located to a different position in the model for better reception.
Crash damage – send the radio to Hobby Services for repair.
RUN TIME IS SHORT: Weak Tx or Rx batteries – replace or recharge the batteries. Obstructed servo
linkages causing excess battery drain – free the linkages / pushrods.
Tx ON BUT SERVOS DO NOT FUNCTION: Weak Tx or Rx batteries – replace or recharge the batteries.
Rx switch is in the off position – turn on the switch harness or ESC. Switch harness or ESC is connected
incorrectly – check all connections and the ESC instruction manual. Rx is not linked to the Tx properly –
perform linking process again.
INTERFERENCE OR GLITCHING SERVOS: Out of range – operate the model more closely to the Tx. Rx
located too closely to engine, motor, or servos or other moving mechanical parts which might be creating
unwanted electrical noise – relocate the Rx inside the model or relocate the ESC.
CONTROL SURFACE MOVES IN THE WRONG DIRECTION: Reverse the position of the reversing switch
for the appropriate channel.
ONLY ONE SERVO GLITCHES: Servo is bad – replace the servo or send to Hobby Services for repair.
FAILSAFE NOT WORKING CORRECTLY: Rx not properly linked to the Tx – re-link and re-try. Contact
Hobby Services for further details.
WIRELESS TRAINER FUNCTION NOT LINKING: Confirm that another 2.4GHz SLT system is not on in your
area. The teacher’s and student’s transmitters were not powered in the proper sequence or are positioned
too far from each other. Carefully follow the instructions on page 7 for proper linking and operation for training.
RECHARGEABLE BATTERIES WON’T ACCEPT CHARGE THROUGH THE TX: Check the charger for
proper setup and operation. Make sure the charge plug is inserted fully into the charge jack. Make sure the
Tx power switch is in the OFF position. Make sure the cells are inserted inside the battery compartment in
the proper direction.
Contact Hobby Services for other problems.
waste. Instead, it is the user’s responsibility to dispo
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC Rf Radiated Exposure Statement: The equipment complies with FCC Rf radiation exposure limits set
forth for an uncontrolled environment.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED
BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID
THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
FCC ID: IYFTTX610
TROUBLESHOOTING
FCC STATEMENT